Route cables under your desk using cable trays, raceways, and velcro ties. This step-by-step guide covers planning the route, mounting hardware, and maintaining clean cable organization as your setup
Cable tray (underdesk mount) or cable raceway Velcro cable ties (not zip ties, velcro allows future changes) Cable labels or washi tape for labeling Power strip with surge protection (mount under the desk near the cable tray) Cable sleeve for the desk-to-floor drop run
Before mounting anything, lay out all your cables on the desk and plan w here each one goes: Identify the power cables (heavier, less flexible, needs to go first) Identify the data/signal cables (USB, HDMI, DisplayPort, audio) Identify the cables that need frequent disconnection (USB for devices you plug and unplug) Cables that need frequent access should route to a location w here the end is accessible from the front of the desk.
Cables that are permanent connections (power, monitor display cables) should be fully bundled and hidden.
Install the cable tray on the underside of the desk toward the back edge.
Mounting it toward the back keeps it invisible from a seated position while providing enough room to route cables along the full desk width.
For a desk without factory cable management holes, position the tray to run from left to right across the full width.
All cables that need to reach the floor drop at one end, typically the side closest to the wall outlet.
Before placing cables in the tray, bundle related cables together: Power strip cord and monitor power cables together HDMI/DisplayPort cables together Use velcro ties rather than zip ties.
Velcro allows you to add or remove cables without cutting the tie.
The cables that run from the desk down to the wall outlet or floor-level power strip need to run along the desk leg or in a wall raceway.
A cable sleeve contains the run cleanly for a desk that is not against a wall.
Add small labels to each cable at the point w here it exits the cable tray.
This saves time later when troubleshooting or reconfiguring the setup.
Our picks
As an Amazon Associate I earn from qualifying purchases. Picks are based on manufacturer specs, independent reviews and owner reports.
DELAMU
Metal mesh trays that screw under a desk to hold power strips, chargers and spare cable.
Legrand Wiremold
A 12-piece paintable raceway kit for hiding up to three cords along walls.
JOTO
A reversible black/white neoprene sleeve you can cut to length and punch exit holes into.
FAQ
A cable tray mounted to the underside of the desk is the most effective solution for hiding cables cleanly. It holds all cables off the floor in a single bundle, keeps them away from chair wheels, and is invisible when sitting at the desk. Pair it with velcro ties to bundle cables together before they enter the tray.
Standing desks need a cable management approach that accommodates height changes. Use a cable cha in or spiral wrap to handle the cables that run from the desk surface to the floor, these need to flex with each height adjustment. Fixed cable trays work fine for the run across the underside of the desk. Avoid routing cables through fixed wall raceways on a standing desk, as the height change will tension or pull the cables.
Most cable trays designed for desks mount with screws. However, clamp-mounted cable trays (which grip the desk edge) require no drilling and no adhesive. Adhesive-mounted cable organizers also require no drilling but have lower weight limits. For a permanent setup, screw mounting provides the most secure result.
Keep researching
